How to drive screws like a pro

Tips on how to use screwdrivers most effectively.

Summary

Using a screwdriver is easy - who needs a page like this? You will often get away with using the wrong screwdriver or not using it properly, but you can easily damage the head making it extremely difficult to remove an obstinate screw.

Safety

Warning03.png
Screwdrivers have pointy ends and although not sharp like a knife, they can cause serious injury if they slip or are misused.


Which way to turn it?

Those who are unaccustomed to using a screwdriver are often uncertain which way to turn it.

The easy way to remember is that it's like a tap (not the modern quarter-turn type):

  • You turn a tap anticlockwise to open it and release the flow of water.
    • You turn a screw anticlockwise to undo it and release whatever it's holding.
  • You turn a tap clockwise to turn it off and hold the water supply.
    • You turn a screw clockwise to tighten it and hold whatever it's fixing.

How to use a screwdriver

Removing a screw

First of all, make sure you're using the right type and size of screwdriver (see next section), particularly if the screw might be tight, or needs to be well tightened.

Make sure you're holding the screwdriver straight and not at an angle to the screw.

Press hard! If you can't turn the screw easily, PRESS VERY HARD!!

If the screwdriver isn't straight or you don't press hard enough to prevent it slipping you are likely to damage the screw head. This is known a "camming out". It can be almost impossible to remove a damaged screw.

If the screw is rusty you may be able to loosen it by applying a little WD40 to the thread and leaving it to soak in.

Inserting a screw

When inserting a screw it's very important to make sure it's straight otherwise you can get a "crossed thread" which will damage the screw or the threaded hole, or both.

If you have any difficulty at all in getting the screw to engage with the thread of the hole, first of all turn it anticlockwise (as if undoing it), pressing gently. You should feel a little click as the first thread of the screw engages with the first thread of the hole. Immediately start turning it clockwise to tighten it.

You can practice this on a jam jar, or any kind of container with a screw top. People often put the lid on crooked so that the screw thread doesn't engage properly and the container doesn't seal. Turn the lid anticlockwise until you feel the click, then tighten it as normal.

A screw should be well tightened, but never so much that the screwdriver slips and damages the screw head.

Types of screw head

There are many types of screw head but just a few common ones. These are the ones you are most likely to come across.

Slotted

Phillips

Pozidriv

Torx

Hex

Choosing your screwdrivers

Single screwdrivers Sets Electric

Rescuing damaged screws

External links

  • External links (if any) as bullet points.
  • If non, delete this section.